3GP Pipe Rack foundation prepared by RMS

RMS offers its clients innovative Engineering and Consulting services as well as interdisciplinary and integrated Project Management in the following fields of competence and business areas. RMS delivers bespoke solutions from single discipline schemes to multi-disciplinary projects ensuring that are our Clients meet their objectives.

Our operations and resources provide expertise in all the major engineering disciplines including but not limited to the below:

  • General Alignment & Layout Plans
  • Building Design
  • Foundation Design
  • Road Design
  • Design of Modular Structures
  • Construction Engineering Support and Supervision
  • Technical Evaluation of Vendor Proposals
  • “As built” based on red line marks ups
  • Bill of Quantities/ Material take off
  • Design Engineering of Static Equipment -Pressure Vessels, Heat Exchangers, Towers, Column & Tanks
  • Project Specifications
  • Performing Design Calculations and Drawings,
  • Prepare Equipment Datasheets & Requisitions
  • Selection of Rotating Equipment (Pumps, Compressors, Gas Turbine, etc)
  • Optimization of Rotating Equipment & Packages
  • Technical Integrity(HAZOP & Value Engineering Studies)
  • Maintenance philosophy
  • Material handling philosophy
  • Construction Engineering Support and Supervision
  • Technical Evaluation of Vendor Proposals
  • “As built” based on red line marks ups
  • Material take off
  • Piping General Alignment & Layout
  • Equipment Layout
  • Piping isometrics
  • Piping Stress Analysis
  • Piping support
  • Piping wall thickness calculation
  • Piping / valve material specification / data sheet
  • Tie-in schedule
  • Valve schedule
  • Technical Evaluation of Vendor Proposals
  • Construction Engineering Support and Supervision
  • “As built” based on red line marks ups
  • Material take off
  • HVAC System Design & Philosophy
  • HVAC System General Arrangement Drawing
  • Heating & Cooling Load calculation
  • HVAC equipment selection Based on load calculation design.
  • HVAC Equipment Static and Dynamic Design Load Calculations
  • Ventilation system & Duct design
  • Constant and variable air volume system
  • Heat / Chilled water pipe and Refrigerant Pipe design
  • Schematic and Single Line Diagram
  • Technical Evaluation of Vendor Proposals
  • Standard installation drawings
  • Construction Engineering Support and Supervision
  • “As Built” Drawings based on Red Line Marks ups
  • Material Take Off
  • Schematic and Single line diagram
  • Load schedule
  • Equipment sizing (Transformer, Emergency generator, UPS)
  • Cable schedule & Cable sizing, interconnection diagram
  • Lighting design
  • Electrical equipment, Lighting, Cable routing, Grounding & lightning  protection layouts
  • Hazardous area design / Equipment selection
  • Electrical heat tracing / Cathodic protection
  • Equipment data sheet and specification
  • Technical evaluation of Vendor’s Proposals
  • Standard installation drawings
  • Construction Engineering Support and Supervision
  • “As built” Drawings based on red line marks ups
  • Material Take off
  • Design Basis and Control Philosophy
  • Instrument Index & Location layout
  • Instrument Datasheet and Specification
  • Cable schedule
  • Instrument cable routing layout
  • Loop Drawing
  • Cable Tray Layout and Conduit routing Diagram
  • Fire & Gas Detection System Philosophy & Specification
  • Instrument hook-up drawing
  • Cause and Effects Diagram
  • I/O schedule
  • Functional Logic Diagram
  • Instrument Installation drawings
  • Construction Engineering Support and Supervision
  • Technical Evaluation of Vendor Proposals.
  • “As built” Drawings based on Red line marks ups